ANVER Vacuum Cups and Suction Cups
Model: Small Oval Cup with Snap-On Reusable Fittings
Part Number: OC10-30-NBR
Vacuum Cup
Part Number
and Material
A
Length
in.
(mm)
B
Width
in.
(mm)
D
O.D.
in.
(mm)
d
I.D.
in.
(mm)
H
Height
in.
(mm)
Pull-Off
Capacity*
at 24 in. Hg
[2:1 Safety Factor]
lb
(kg)
Pull-Off
Capacity
at 24 in. Hg
[4:1 Safety Factor]
lb
(kg)
Fitting
Type
Suspension
Group
OC10-30-NBR
(Nitrile)
1.18
(30)
0.39
(10)
0.47
(12)
0.20
(5)
0.47
(12)
1.10
(0.500)
0.55
(0.250)
Notes:
The cup capacities shown above ( * ) are based on 24″Hg at sea level with a safety factor of two (2). This is the US ANSI ASME Standard B30.20 for vacuum lifter specifications and is commonly used in North America as a design capacity for vacuum components. When used in vertical applications, take these values and divide again by 2 to obtain a 4 to 1 safety factor per the ANSI specifications. These are realistic working capacities when designing equipment.
Other manufacturers use a pull-off figure at 27″Hg to show a high capacity value for their cups. This is accurate, but requires users to do all the math themselves to build in safety factors. The values are basically the same, but it is necessary to calculate the working capacities with a safety factor via the following formula at sea level:
Pull-off value (at 27″Hg) = ANVER’s Listed Capacity x 2 x 1.125 (at 24″Hg)
