ANVER Vacuum Material Handling

• ANVER divides small universal suction cups into three groups based on mounting specifications and style. Group Two Fittings, shown here, are those that push in from the bottom, exposing a male thread at the top of the cup.
• Within each vacuum fitting group, the hardware is interchangeable with all other cups within the group. Any Group 2 fitting will fit any Group 2 cup. 
• These all-metal, electro-less nickel-plated brass fittings are reusable. Once you buy the cups with fittings, you only need to buy replacement rubber cups in the future.
• The cup is held from the bottom flange of the fitting, which is screwed into a female connection above the cup to hold it tight. Replacement takes only a few seconds – simply unscrew the fitting, replace the cup, and screw the fitting back on using your hand or screw driver. 
• These specific cup fittings are top quality, production grade fittings made by ANVER Corp. in the USA.

Vacuum Fitting
Part No.

Thru Hole Dia.
or Thread
in.
(mm)

H
Height
in.
(mm)

The HS5 fitting screws into the SLSA-1 Suspensions without a top nut

HS5

0.11
(2.7)

0.71
(18)

The HS10-32 fitting screws into any HS1032-1032F fitting or mounting (also screws into M5 female)

HS10-32

0.10
(2.5)

0.71
(18)

The HS6 fitting screws into any HS6 fitting or mounting

HS6

0.14
(3.5)

0.79
(20)

The HS8 fitting screws into any 8 mm female fitting or mounting

HS8

0.20
(5.1)

0.79
(20)

The HS8-303 fitting screws into any 8 mm female fitting or mounting

HS8-303
(303 Stainless)

0.20
(5.1)

0.79
(20)

F30-, F35-, F40-, F52-, F60-

B1.5-33-, B1.5-43-, B1.5-53-, B1.5-63

B2.5-32-, B2.5-42-, B2.5-62